Simulink Raspberry Code Generation Running Very Slow

I am trying to compile a simple gpio trigger signal that I created with Simulink and run it on the raspberry. But unfortunately, when I measure with an oscilloscope from the gpio pin, which should trigger 2khz, I see a 2hz measurement. I would appreciate if you can help with this. It is interesting that even very simple models have such problems. (Matlab2024a)

[Amish]

Hi Burak,

A few debugging steps that I could suggest:

1. Verify the sample time of the blocks in your Simulink model as it can affect the frequency of the output signal.
2. Set the solver type to Fixed-step and choose a fixed-step size that matches your desired sample time (e.g., 0.0005 seconds for 2 kHz).
3. In the Hardware Implementation pane, ensure that the hardware board is set to Raspberry Pi. Make sure you are deploying the model correctly to the Raspberry Pi.
4. Ensure that the GPIO block in your Simulink model is configured correctly. Double-check the pin number and mode.

I hope these might help you resolve the issue.