MATLAB Simulink Task 5 Power Systems Simulation Incorrect Output Description

I'm working on the MATLAB Simulink Power Systems Simulation Onramp, specifically Task 5. I changed the Wye-Connected Load block component structure to Series RL and set the default value to 12∠0° (A) for inductive reactive power, as required. I also used the filter from the previous task to extract the reactive power from the Q port of the Power Sensor and connected the filtered measurement to the Signal Assessment block. However, I still receive an incorrect output error.

Could anyone help identify what might be wrong?

Answer 1

[Cris LaPierre]

See this answer.

This is happening because the default value for one of the Wye-Connected Load block parameters has changed in R2024b.

Under Parasitics, change the Parasitic parallel conductance to 0. Keep the units as 1/Ohm.

Now submit.

[Eric John]

Hi Cris, All good Thanks so much man you're a MVP :)