GUI screen size problem

Hi,

I created GUI with GUIDE on a computer, and now, I open my GUI files (fig) on another computer and I can't see the at least the half top of my GUI. The two computers have the same resolution (1900 x 1080). Please, could someone give a hint how to resolve that ? I need to go back and forth between the two computers. I changed to Characters everything, none. To pixels, none. To Normalized, none. My GUI is still out the screen Thank you.

[Walter Roberson]

Does the one that there is a problem have dual screens?

Which operating system is being used?

[Joseph Cheng]

to debug it a bit i'd stick in

 disp(get(hObject,'position'))

in the OpeningFcn to see where both computers put the GUI. if anything you can force the GUI to open on a certain position with

 pos = get(hObject,'position');
 set(hObject,'position',[0 0 pos(3:4)]);

which will load it into the lower left corner but keep the same height and width. substitute the [ 0 0] with an offset that should make it center if that's what you want.