How to put the parameter of a controller as an increasing variable, so that after each simulation it increases itself and simulates automatically. I do not want to enter a value each single time manually and wait for the simulation.
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have a PI2DOF Controller. I want to check the results(scope) with different I- Parameters of the Controller. For example from (0.1 to 3.0). How can I put this Parameter as an increasing variable, which increases by 0.1 after each Simulation? I cannot enter each value manually after each Simulation. I want to see the difference in the behaviour with all These 0.1 to 3.0 I- Parameters of the Controller. Please help!
0 commentaires
Réponses (1)
Naty S
le 3 Fév 2016
The parameter you want to test should be taken from the workspace, then you could run the simulation in a for loop in a matlab code using the sim command http://www.mathworks.com/help/simulink/ug/using-the-sim-command.html
after that you could just plot the data you need with the hold all command.
Besides that simulink has some good tolls using the PID Tune controller to examine the gain, you main want to test those.
6 commentaires
Voir également
Catégories
En savoir plus sur Classical Control Design dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!