How to generate deadband between two complimentary pulses of inverter.

There should be a proper dead-band between two pulses of switches of one lag of inverter, to avoid shoot through. Dead-band will make rising edge of each pulse delay by defined time. We can generate dead-band by use of analog circuit and set it's value by design of R-C network in hardware. But is there way to make a complimentary pulses with proper microsecond dead-band in matlab simulink??

[Darshan Joshi]

did you find the solution..?

[abhilash reddy chelimeti]

Do someone have the answer for the above question?

Answer 1

[Dr. Pemendra Kumar Pardhi]

Hi,

In MATLAB Simulink, deadband can be provided by using dead zone or on/off delay (continuous) or on/off delay (discrete).

If any third party support like C2000 hardware support package and its EPWM block is used then there are also provisions available to provide a deadband time.

Thanks,

Pemendra

[Arifin]

Hi,

how to generate deadband smaller than Ts ?

I am working with MPC for control MPC.

the output MPC connected to GPIO Output.

however i need to add deadband between MPC and GPIO.

Ts = 50e-6. and i would like to generate deadband 1e-6.