How to set the input and target in power state estimation using neural network?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hossam Mosbah
le 14 Juil 2016
Commenté : Dina Elsafy
le 20 Déc 2023
I am doing an experiment on power system state estimation using neural network for IEEE 14 bus system with fully observed. Fully observe means all sensors are working and all measured data from sensors are transmitted to the control center. So I set the input as measured data (available measurements) and target as the true state variables (load angle and magnitude voltage), however the measured data (input) has different samples from the target (state variables), so can we set every type of input as vector. For example, active power injections as a first vector (row) in the input matrix, reactive power injections as a second vector (second row) and the same for active power flow and reactive power flow. Or it is wrong and we have to set all measurements as one vector as we do when we use weighted least square, kalman filter, linear programing and so on.
3 commentaires
Dina Elsafy
le 20 Déc 2023
Hi Sir,
Iam doing a research in the area of Deep learning state estimation in power system , please can you send to me the model and code of the above work.
Réponse acceptée
Greg Heath
le 14 Juil 2016
For N pairs of I-dimensional "I"nputs and resulting O-dimensional "O"utput targets
[ I N ] = size(input)
[ O N ] = size(target)
Hope this helps
Thank you for formally accepting my answer
Greg
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Power and Energy Systems dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!