Simulink Real-time position of target scope on screen

Hello everyone,

I am working with a SpeedGoat target machine and so far everything works fine. I am plotting signals on the target pc screen with the Simulink Real-Time Scope block, but I can't find a way to decide where in the target screen those scopes should be placed I would like for documentation purposes to have one scope in the top half of the screen and an other one on the bottom half. But The Real-Time GUI places both scopes on the top half of the screen one next to the other leaving the bottom half unused. Is there any way to control that?

I looked for information on this but did not find anything useful.

Thank you very much in advance. Best regards Camilo

Answer 1

[Yinghua Chen]

I have the same problem, anyone has the solution?

Best regerds.