Problem related to powergui block

whenever I run my model following errors occur how do I solve these.

    1)Error in port widths or dimensions. Output port 1 of
    'practice/powergui/EquivalentModel1/Gates/From2' is a [1x2] matrix.

    2)Error in port widths or dimensions. Invalid dimension has been specified
    for input port 2 of 'practice/powergui/EquivalentModel1/Gates/Mux'.

I am using 1x2 size matrix which is the requirement. How do I solve these problems.

Answer 1

[ALBERT ALEXANDER STONIER]

It is only because of the dimensions which you have specified for the signal. Kindly change the dimensions and proceed with.

[Jasmine Jones]

I have tried to edit powergui and I still have the same errors? My simulation will not work without it but with the powergui in I get the fault mentioned above?

Answer 2

[Prabhat Singh]

I am not able to see FFT analysis by powergui block. Simulation run but after clicking on FFT analysis it is not sowing the resuts. I have made all the settings properly is scope also.