Why am I unable to complete installation of MATLAB R2016b when installing from the 2 ISO images I downloaded?
11 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
MathWorks Support Team
le 14 Oct 2016
Modifié(e) : MathWorks Support Team
le 12 Déc 2018
I have downloaded and mounted both of the ISO images required to install MATLAB R2016b on an offline machine. During installation, I receive the following message:
Eject DVD 1 and insert DVD 2 to continue
How can I proceed with installation?
Réponse acceptée
MathWorks Support Team
le 12 Déc 2018
Modifié(e) : MathWorks Support Team
le 12 Déc 2018
This error will occur if the mounted ISO for DVD2 cannot be found at the mount point that MATLAB is searching for it.
To resolve this error, un-mount all MATLAB ISOs you currently have mounted on your computer through your mounting utility of choice, then mount *only *the DVD2 ISO. (Do not close out of the MATLAB installer while un-mounting/mounting your ISOs.) You should now be able to proceed with the MATLAB installer.
Additionally, if you are unable to mount the other disk you can alternatively create a single installation package to install MATLAB. Please refer to the article below on this process:
How can I obtain a single installation package for MATLAB with the ISOs (Merge the ISO Images)?
0 commentaires
Plus de réponses (2)
hopei helpedu
le 16 Oct 2016
U should see 2 new disc while u re installing setup since u have 2 iso file. When u get that warning, eject the disk1 by right click&eject option; then go (device manager)/storage/(disk management) and then find your 2nd iso file disc, right click on it and select "change drive letter and paths" option, finally change your drive letter to one early belong to your disc 1. Now you can continue to installation. Sorry if the description is a bit messy :) (eg. While u re installing u ll see disc1:F & disc2:G; eject ur :F disc and change label of disc2 G to F)
0 commentaires
Muhammad Awais Manzoor
le 11 Fév 2018
After downloading iso formats of both cd. cd1(around 7 GB) and cd2(arounf 2.5 GB), do the following steps: 1). Unmount CD1 and install that.
2). then it would ask you to eject cd1 and insert CD2 at this point you have to open My Computer and from there you have to eject CD1 by right clicking on it.(but rememeber the drive name)
3). Now unmount CD2(but be careful because the drive name for CD2 must match the drive name of CD1).
4). Now press OK on the pop up which was asking for inserting CD2.
Done. Now it should be installed.
That worked for me and i hope that would work for everyone.
0 commentaires
Voir également
Catégories
En savoir plus sur Introduction to Installation and Licensing dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!