getsnapshot does not give clear image
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I wrote a code for image acquisition,when i get a live video using ' videoinput' function i get clear live video. but when i use getsnapshot function to get captured image from live video, i dont get clear image. plz give me solution of this. thank you.
imaqhwinfo
info = imaqhwinfo('coreco')
info.DeviceInfo
%dev_info = imaqhwinfo('demo',info.DeviceInfo.DeviceID);
vid=videoinput('winvideo',1,'YUY2_640x480');
preview(vid)
frame = getsnapshot(vid);
image(frame);
delete(vid);
1 commentaire
Réponse acceptée
vish
le 3 Mar 2012
Your image snapshot is in YUY2 format. What you need to do is convert your YUY2 image to RGB. You can find one on file exchange section.
2 commentaires
Image Analyst
le 3 Mar 2012
If that's the problem there should be a rgb mode that shows up in the winvideo category of the hardware browser when he runs imaqtool. He should pick one of the RGB modes.
Plus de réponses (1)
Image Analyst
le 3 Mar 2012
Define "clear". It should look fairly similar but maybe noisier. A single snapshot will always appear noisier than a video stream. Also be aware that some cameras have two different sets of settings, one for video mode and one for snapshot mode. You could be adjusting the camera to look good under video but then when you switch to snapshot mode, it's using a different set of settings. This could be what's happening if it's more than simply a noisier image. Consult Coreco for how their cameras work. Also, you might want to use the Coreco driver built for their camera, if they have one, rather than the generic winvideo driver.
0 commentaires
Voir également
Catégories
En savoir plus sur Image Acquisition Support Packages for Hardware Adaptors (Generic Video Interface) dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!