Can BrickPi be programmed from Matlab/Simulink to control LEGO NXT sensors and motors?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi, Has anyone tried controlling LEGO NXT sensors and motors via BrickPi over Raspberry Pi 3's on-board WiFi? BrickPi is essentially an expansion board to Raspberry Pi: https://www.dexterindustries.com/BrickPi/.
BrickPi officially does not support Matlab/Simulink yet. I am wondering if anyone can point me to relevant resources to help figure out how to access and control these motors and sensors. Thanks, Gautam
1 commentaire
René van der Meer
le 24 Déc 2017
Gautum, this is a very good idea! I would love to use this as well. I hope that someone already has done this. Otherwise would could start with the Dexter SW?
Réponse acceptée
Jannik Hahn
le 9 Déc 2019
Hi Gautam,
maybe a bit late, but you can use the "Simulink Support Package for Raspberry Pi Hardware" and control the motors and sensors via SPI. I actually use the "SPI Master Transfer" and extract the needed inputs from the c++ libraries provided by Dexters BrickPi3-master.
Cheers Jannik
6 commentaires
Plus de réponses (0)
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur LEGO MINDSTORMS EV3 Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!