A command such as "figure('Position',[800 650 560 420])" also displays the figure in top left corner before going to specified position. It seems that some internal setup procedure is prematurely displaying the figure.
Odd initial figure behavior in R2016b
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
William Vaughn
le 27 Fév 2017
Modifié(e) : Sindhu Priya
le 7 Mar 2017
Just installed matlab R2016b(64bit) on Fedora 25 and found that the figure command exhibits a strange behavior: the figure shows up in the top left corner of my screen momentarily and then jumps to the position set by 'DefaultFigurePosition'. Quite annoying. How do I get the figure to display in the right place initially?
Réponse acceptée
Sindhu Priya
le 7 Mar 2017
Modifié(e) : Sindhu Priya
le 7 Mar 2017
As MathWorks officially did not support all flavors of linux (check this link for supported platforms)
All functions may or may not work as expected.
Possible work around for the issue is,
copy the following command to startup.m file in MATLAB’s Startup Folder (or create a new 'startup.m' if one does not already exist)
>> set(0,'defaultfigureposition',[800 650 560 420]);
Regards,
Sindhu
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Startup and Shutdown dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!