How to continously run and display the simulink results ?

Hello,

I usually run simulation in Simulink and send the results to simulink scope. After the simulation stops, I open the scope to analyze the data.

Is there a way to continuously run simulation in Simulink and display the result in the simulink scope during the simulation ? I don't need a very fast simulation, just need to see the simulation results during the continuous simulation. This is for a live demonstration for our algorithm.

Any suggestions are highly appreciated.

Thanks a lot,

Tom

Answer 1

[mohamed al-asklany]

you can adjust simulation time to inf then use your scope you can watch your signal

[Tom]

Thank you very much Mohamed Al-asklany. It works.

[mohamed al-asklany]

it's my pleasure

[CET. Mak]

Nice one Moha. It assited me too

[mahmood MDMD]

thank you Mohamed . nice