Using NaN in if and interp1 commands
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi everbody, I have 6 values and some values are NaN. If interp1 command finds the final value as NaN for giving ' c' value, MATLAB must give me error message.
a=[1 2 3 4 5 6];
b=[10 15 20 NaN NaN NaN];
c=[1.5 4 3.5 4.5 5.1 5.9];
for g=1:1:numel(a)
if interp1(a,b,c(g))==NaN;
disp('There is a mistake here')
end
end
But MATLAB does't run this command with NaN values.
*In interp1 at 178
Warning: NaN found in Y, interpolation at undefined values
will result in undefined values.*
How can i achieve this problem? How can i use NaN values in interp1 and if command? I get the problems when i use isnan.
Thanks...
2 commentaires
per isakson
le 25 Mar 2017
c(g) is a scalar. Why not replace
if interp1(a,b,c(g))==NaN;
by
if isnan( interp1(a,b,c(g)) )
?
Réponse acceptée
Jan
le 25 Mar 2017
Modifié(e) : Jan
le 25 Mar 2017
It is tzhe definition of NaN, that any comparison with it is false, even NaN == NaN. Therefore
if interp1(a,b,c(g))==NaN;
will most likely not do, what you expect. I assume you want:
for g = 1:numel(c) % Not numel(a) !??
cg = interp1(a, b, c(g));
if isnan(cg)
disp('There is a mistake here')
end
end
Or without a loop:
cg = interp1(a, b, c);
if any(isnan(cg))
disp('There is a mistake here')
end
I do not get a warning in R2016b.
1 commentaire
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Multirate Signal Processing dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!