How to read low amplitudes on a scope in simulink?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm trying to measure the peak-to-peak of the attached signal. But as you can see, all numbers are in the same order of magnitudes.
So is there any way to export these signals to workspace so that I can plot on a figure and use the cursor to see a precise numbers? or is there a solution in simulink itself?
0 commentaires
Réponses (0)
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!