In a Simulink model, Check at simulation time 't' (eg. @t=3sec) what is the value of a signal (signal is from signal builder).
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi, I have a signal (eg: sine wave) from signal builder block. When I run the model, I need to check at simulation time 't' (eg. @t=3sec) what is the value of that signal. Based on that value I'll be doing some logic. How can I achieve this?
0 commentaires
Réponses (1)
Astik Sachan
le 26 Mai 2017
Modifié(e) : Astik Sachan
le 30 Mai 2017
It gives current time stamp as output.
Please refer Sample Model "Clock.png" attached below!
2 commentaires
Astik Sachan
le 30 Mai 2017
Modifié(e) : Astik Sachan
le 30 Mai 2017
You can sample the value at that time stamp with the help of a Clock block and trigger subsystem.
Voir également
Catégories
En savoir plus sur Sources dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!