How to connect 2 different air stream in simscape pneumatic

5 vues (au cours des 30 derniers jours)
Xavier
Xavier le 5 Juil 2017
Modifié(e) : Prashant Arora le 18 Juil 2017
I am using Matlab R2012b (a requirement) and I am modeling the leakage around the seal of a pneumatic piston using simscape pneumatic toolbox. I have 2 different air source (different Temperature and pressure) on each side of the piston ( I can have 2 different gas property block for each circuit). When I connect the 2 circuit with a fix orifice to simulate the leakage between chamber then I can only have one gas property block in the system so one side of the circuit has the wrong air properties.
Question is How to mix 2 gas (same gas different properties) in Simulink simscape?
I do not care what happen during the mixing process. all I want is to to study the effect of the leakage based on the gas properties on the 2 circuits on the motion of the cylinder.

Réponses (1)

Prashant Arora
Prashant Arora le 18 Juil 2017
Modifié(e) : Prashant Arora le 18 Juil 2017
Hi Xavier,
I don't believe there's a capability to mix two gases. You can calculate the approximate properties manually and put it in the Gas Properties block to get an estimate from the model.

Catégories

En savoir plus sur Gas Models dans Help Center et File Exchange

Produits

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by