target angle set up in a radar simulation without phase shifter
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Xining Yu
le 25 Juil 2017
Commenté : Honglei Chen
le 26 Juil 2017
Hello Everyone
I am designing a radar system with patch antennas WITHOUT phase shifter. I want to use monopulse or other techniques to know the direction of arrival. How can I setup the angle for the radiator and collector. For example, in the following pseudo code, it defines a radiator and a collector.
radiator = phased.Radiator('Sensor',ura_t,'OperatingFrequency',fc);
collector = phased.Collector('Sensor',ula_r,'OperatingFrequency',fc);
And then I start to transmit and receive the signal, like this:
[tgtrng,tgtang] = rangeangle(tgt_pos,radar_pos);
broad = [0;0];
% Transmit
txsig = radiator(txsig,tgtang);
% Propagate the signal and reflect off the target
txsig = channel(txsig,radar_pos,tgt_pos,radar_vel,tgt_vel);
txsig = target(txsig);
% received radar return
rxsig = collector(txsig,tgtang);
Based on the above code, in the "radiator" and "collector" functions, should I use the "tgtang" or "broad" as the angle? Again, note that this radar do not have phase shifter.
Thanks
Xining
0 commentaires
Réponse acceptée
Honglei Chen
le 26 Juil 2017
You should use tgtang. Note that what you do here is to synthesize the data. Therefore, even though the radar is not steering, you need to know what is the corresponding directional response of the radar toward the target. Therefore you need to use the direction toward the target.
HTH
2 commentaires
Honglei Chen
le 26 Juil 2017
STEERANGLE is only applicable when you have a subarray. In that case, you only have access to apply weight at the subarray level. Within each subarray, the elements could have phase shifters so to enable those phase shifters, you specify STEERANGLE input.
HTH
Plus de réponses (0)
Voir également
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!