INA219 Current Sensor Integration with MATLAB
49 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi There,
I am trying to use a INA219 current sensor to obtain the voltage and current and thus power from a Solar Panel. This chip works with an arduino. I have coded in arduino and got the values i require however when I try to read these values on MATLAB I cannot get it to work.
The Code that I have written is Here:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
clc clear all
a = arduino;
INA219 = '0x40';
INA219_ADC_CH0 = '40'; % getBusVoltage_V
INA219_ADC_CH1 = '41'; % getVoltage_mV
INA219_ADC_CH3 = '43'; % getCurrent_mA
i2c = i2cdev(a,INA219);
disp(['getBusVoltage_V ', 'getVoltage_mV', 'getCurrent_mA']);
while 1
getBusVoltage_V = read_adc(i2c,hex2dec(INA219_ADC_CH0));
pause(0.5);
getVoltage_mV = read_adc(i2c,hex2dec(INA219_ADC_CH1));
pause(0.5);
getCurrent_mA = read_adc(i2c,hex2dec(INA219_ADC_CH3));
pause(0.5);
disp([getBusVoltage_V,getVoltage_mV,getCurrent_mA]);
end
function adc = read_adc(dev,config)
write(dev,config);
read(dev, 3);
out = read(dev, 3);
adc = out;
end
~~~~~~~~~~~~~~~~~~~~~~~~~~~
Where the output is:
60 0 0
31 3 0
255 255 255.
I was expecting an output of roughly:
2.46 0.03 0.07
*obtained from my arduino code.
I cannot seem to find where I've gone wrong, perhaps my limited knowledge in the area. Any help you could provide to rectify this would be great.
Regards,
Jayden
3 commentaires
Raul Ballesteros
le 28 Mai 2019
I have the same problem If find the solution Please share the vos es Thanks
Réponses (1)
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!