Matlab doesn't read color video

Hello everyone. I have a problem with reading color video in Matlab. It reads grayscale video properly, but when i try to load color(RGB) video it reads only the first frame of the video. I use Matlab in Linux.

I have a code from gstreamer: for a grayscale video

>gst-launch-1.0 tcambin serial=19710151 ! >video/x-raw,format=GRAY8,width=1280,height=720,framerate=30/1 ! queue ! >videoscale ! video/x-raw,format=GRAY8, width=640,height=480 ! queue ! >videoconvert ! avimux ! filesink location=output.avi >

for color video: >gst-launch-1.0 tcambin serial=19710151 ! >video/x-raw,format=BRGA,width=1280,height=720,framerate=30/1 ! queue ! >videoscale ! video/x-raw,format=BRGA, width=640,height=480 ! queue ! >videoconvert ! avimux ! filesink location=output.avi

[Jan]

Please use the "{} Code" button to format code. Do you see, that it is hard to read currently?

I do not know "gstreamer". The code does not look like Matlab. Maybe you use the PsychToolbox? If so, please mention such details.

[Mykyta Slyvkanych]

 >gst-launch-1.0 tcambin serial=19710151 !
 >video/x-raw,format=GRAY8,width=1280,height=720,framerate=30/1 ! queue ! 
>videoscale ! video/x-raw,format=GRAY8, width=640,height=480 ! queue ! >videoconvert ! avimux ! filesink location=output.avi >

It is the code not from matlab, but from gstreamer for recording video on linux, the problem is matlab doesn't read this video properly, only the first frame

[Adam]

You haven't shown the Matlab code you use to read the video so there's not a lot to say other than to assume you are correct in that your Matlab code doesn't read that particular video correctly.