how ro make a cross section for a meshplot

i just ploted a Sphere with a hole and i wanted to make the cross section von x-z axis .here there are the Code of my sphere.

phi=linspace(0.52,2.62,30); theta=linspace(0,2*pi,40); [theta,phi]=meshgrid(theta,phi); rho=2; X=rho*sin(phi).*cos(theta); Y=rho*sin(phi).*sin(theta); Z=rho*cos(phi); mesh(X,Y,Z,'EdgeColor','blue') hold on z=linspace(-sqrt(3),sqrt(3),40); theta=linspace(0,2*pi,40); [z,theta]=meshgrid(z,theta); r=1; x=r.*cos(theta); y=r.*sin(theta); mesh(x,y,z,'EdgeColor','red')

Answer 1

[Darshan Ramakant Bhat]

The following MATLAB answer posts discusses about the similar issue:

https://www.mathworks.com/matlabcentral/answers/231881-hello-i-want-to-get-a-diagonal-cross-section-cut-of-the-mesh-plot-and-want-to-get-a-2d-plot-whic

https://www.mathworks.com/matlabcentral/answers/13152-how-to-plot-a-cross-section-of-a-surface-plot

https://www.mathworks.com/matlabcentral/answers/197112-is-it-possible-to-take-a-cross-section-at-different-points-of-a-3-d-plot

https://www.mathworks.com/matlabcentral/answers/278585-plot-cross-section-at-particular-value-of-x-for-mesh-x-y-z

I hope this will help you.