How can i model the engine starting behavior in simulink with Generic engine block and motor? Can anyone provide an expert opinion on this?
8 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello, I want to model the engine starting scenario in simulink. I have the DC motor connected to battery. Motor and Engine are connected to a gear block. The engine is getting started, After that, both the engine and motor start to rotate in the same speed. Since the signal is torque, I am not able to disconnect the motor as soon as the engine gets started. Could you please help me with a solution?
0 commentaires
Réponses (1)
Martin
le 11 Juin 2018
The best way to model something like this is to think about what happens in the real system. So far, it sounds like a good start. In the real system, how does the starter motor determine when it should turn off? Does it run for a fixed time? Is it dependent on engine speed? If the time is fixed consider using a Signal Builder or Step block to have the torque go to zero after some time. If the starter motor turns off after the engine reaches a target value, consider adding a rotational velocity sensor to the engine output, and feeding the result to a conditional switch. The conditional switch could output 0 once the target speed is reached.
1 commentaire
johnson saldanha
le 17 Juil 2019
which is the conditional switch you are referring to. Could you please give an example
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Powertrain Reference Applications dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!