Cant get complete adc data using c2000 in external mode
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am using c2000 ADC pins in external to monitor phase currents and voltages data using a hardware interrupt. The hardware interrupt uses ePWM for generating interrupt. I am trying to see the data on a scope, I am getting the data with a lot of missing points. I am running the model at a sampling time of 1ms. If I decrease the sampling time I get an error 'Failed to connect to target'.
Any ideas to solving this problem will be appreciated.
Thanks and regards, Akshay.
1 commentaire
Réponses (1)
Venkatesh Chilapur
le 16 Fév 2018
Please run through TASK 3 from link below and see if it helps: https://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/examples/parameter-tuning-and-signal-logging-with-serial-external-mode.html
0 commentaires
Voir également
Catégories
En savoir plus sur C2000 Microcontroller Blockset dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!