Why am I getting an error using PV array block with P+O MPPT and boost converter in simulink? (algebraic loop error)
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm trying to create a simulink model using the built in PV array connected to a P+O MPPT method which feeds the duty cycle into a boost converter. When running this error comes up:
Simulink cannot solve the algebraic loop containing 'PV_final_1/PV Array1/Diode Rsh/Product5' at time 0.00014 using the LineSearch-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues.
Error doesn't always come up, only with certain setting in the PV array.
I have included photos of the whole model, and the MPPT method.
2 commentaires
Aveek Podder
le 20 Avr 2018
Could you please share the model with the required settings in PV array?
Réponses (2)
Seyma Biskin
le 28 Avr 2018
Hello, Have you solved this problem. I am using Incremental Conductance MPPT method and using PWM signal output to feed the dc-dc boost converter and getting this error:
An error occurred while running the simulation and the simulation was terminated Caused by: Simulink cannot solve the algebraic loop containing 'micro_grid_last/PV Array/Diode Rsh/Product5' at time 0.028926999999999998 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('micro_grid_last','AlgebraicLoopSolver','LineSearch') b) reducing the VariableStepDiscrete solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
Almost same with yours. I will be grateful if you can share any info that can help to solve this frustrating problem. Thank you in advance.
1 commentaire
sdas sda
le 19 Oct 2018
Hello,sir. Have you solved this problem.I met the same problem in Pv simulink. I will be grateful if you can share any info that can help to solve this. Thank you in advance. I hope you solve this problem.sir
0 commentaires
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Electrical Block Libraries dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!