Communications System Toolbox Support for Xilinx Zynq-based SDR - is the Xilinx ZC702 board supported?

Hello

When configuration hardware support for this add-on, I can select the Xilinx ZC706 board but I was wondering if anyone was using the Xilinx ZC702 board and, if so, if they could post how they did it?

I have tried configuring my ZC702 using as a ZC706 but the board does not seem to boot from the resulting SD card image (ie the 'done' light does not illuminate and there is no Ethernet comms to the board).

Many thanks Kevin

Answer 1

[Neil MacEwen]

Hi Kevin,

Unfortunately the ZC702 is not on our list of supported devices. The ZC706 and ZedBoard both have different hardware and software configurations to the ZC702, and it would not be a straightforward task to set up the ZC702 using one of those as a starting point.

The ZedBoard hardware has exactly the same chip as the ZC702, so that would be the closest you could get I'm afraid.

Kind regards,

Neil

[Kevin Scarr]

Thanks, Neil

I will look into finding a Zedboard.

Best regards Kevin