F28069 Simulink Time Step
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi all,
I'm trying to produce a simple simulink model to read data from four SPI slave ADCs. The f28069m SPI peripheral has only on "Chip Select" line so I have taken TI's advice and used GPIO pins as "Chip Select" lines.
When I run this on the external target, it executes MUCH slower than I would expect. The time step for the program would appear to be 100ms, as shown in the attached oscilloscope capture. How can a change this time step as it is set to 100e-6 in the simulation settings?
Thanks.
0 commentaires
Réponses (0)
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!