How to turn a 3 phase line into a single line in a Simulink diagram?

I have modelled a diesel generator on Simulink with the help of Simscape power systems and this serves as a 3 phase (A,B,C) source to a load. I have many more loads and energy storage systems to connect to this microgrid but there is always 3 lines that I have to connect. Is there any way to bundle these 3 lines into just one line to make the diagram look neater?

This is to create a single line diagram.

I tried using the BusCreator but it did not connect to my source because its not a signal that's being output by the Simscape block- it's a power source (electric current)

Many thanks!

Answer 1

[Sambit Senapati]

You need to convert the three lines coming from source to simulink signal using PS-Simulink converter block. Now, use buscreator to club these lines. In order to connect back these signal to simscape block use an Simulink-PS converter block.

[Akash Menon]

Thanks a lot!! That really helped!

[aldi julio]

I have a problem to convert single line diagram to 3 phase. Is there any way to convert it ?

[Kim]

Hi, I also would like to know if there is a way to go from a single line 3-phase to 3 seperate lines in Simulink for measurements.