MATLAB Answers

0

How to turn a 3 phase line into a single line in a Simulink diagram?

Asked by Akash Menon on 10 Sep 2018
Latest activity Commented on by Akash Menon on 21 Sep 2018
I have modelled a diesel generator on Simulink with the help of Simscape power systems and this serves as a 3 phase (A,B,C) source to a load. I have many more loads and energy storage systems to connect to this microgrid but there is always 3 lines that I have to connect. Is there any way to bundle these 3 lines into just one line to make the diagram look neater?
This is to create a single line diagram.
I tried using the BusCreator but it did not connect to my source because its not a signal that's being output by the Simscape block- it's a power source (electric current)
Many thanks!

  0 Comments

Sign in to comment.

1 Answer

Answer by Sambit Senapati on 21 Sep 2018
Edited by Sambit Senapati on 21 Sep 2018
 Accepted Answer

You need to convert the three lines coming from source to simulink signal using PS-Simulink converter block. Now, use buscreator to club these lines. In order to connect back these signal to simscape block use an Simulink-PS converter block.

  1 Comment

Thanks a lot!! That really helped!

Sign in to comment.