How to change signal value at intermediate steps in Simulink?

I have a Simulink model for two sensors. The first sensor has a frequency of 1 Hz and the second at 5 Hz. I am using a rate transition block to get the outputs at different rates.

How do I set the lower sensor, the one at 1 Hz, to output zeroes at intermediate steps?

    TIME STEPS   1  2  3  4  5  6  7  8  9 10 11 12 13 14 15 16 17 18 19 20     
    sensor1      x  x  x  x  o  x  x  x  x  o  x  x  x  x  o  x  x  x  x  o      
    sensor2      o  o  o  o  o  o  o  o  o  o  o  o  o  o  o  o  o  o  o  o

I want sensor1 to output zeros, not to hold the signal at intermediate steps.

Answer 1

[Jesús Zambrano]

Hi Luis,

You could try include the sensor1 model in an enabled subsystem,

https://www.mathworks.com/help/releases/R2019b/simulink/slref/enabledsubsystem.html

which can be controlled at 1Hz, when is enabled it shows the sensor value, when is disabled you can set it to show a certain value (0 in your case). See picture below