Simulink &TI f28379d ADC configuration

Hello everyone

I would like to acquire a signal from a current sensor (ACS712) using TI f28379d & Simulink, but I can not get a stable data from the ADC even using a constant and known voltage source.

Specifically, the sensor should measure the discharge current of a battery (2.5 A) by performing readings with a frequency of 10-100 Hz.

I attach the files used for the tests: Drive

Any ideas on how to configure the parameters to make a consistent reading?

Thanks, Tommaso.

[SHAMSUL AREFEEN AL MAHMUD]

Hello, did you able to get any solution for this issue? I am using the similar kind of current sensor and trying to connect with F28379D ADC. I ma having problem with configuring the ADC pin. I tried to get some values in ADC using software triggering but not working at all. I was giving 2 or 3 volts supply from a dc source.

Answer 1

[Yash]

To get a stable output you can use a relay block available in Simulink. This may help you to get a stable value within the range you specify.