Temperature Control using PID via Simulink

4 vues (au cours des 30 derniers jours)
Mitchelle Law Jyy Jinn
Mitchelle Law Jyy Jinn le 3 Fév 2019
Réponse apportée : Ege Keskin le 3 Fév 2019
I found that after i insert PID parameters in the model, the lightbulb keep on flickering due to fluatuated duty cycle. Also, i found that no improvement is done using the PID parameters . Does this means PID dont have any function at all in improving the lightbulb performance? Theorectically, PID suppose is better than using ON/OFF and Deadband as it could reduce flickering. The results obtained is opposing the theory. Whats wrong with the model build as shown in Figure below?

Connectez-vous pour répondre à cette question.

Réponses (1)

Ege Keskin
Ege Keskin le 3 Fév 2019
You might achieve better results by directly using the PID block on simulink.

Catégories

En savoir plus sur PID Controller Tuning dans Help Center et File Exchange

Tags

Produits

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by