How to interact Matlab with Arduino and Motor Shield Rev 3?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello,
I've been trying sync up Matlab and Arduino (along with a rev 3 motor shield) in order to controlk a DC motor.
After creating an arduino object, along with the add on object.
As specified below, the problem comes when creating a dcmotor object.
Is there a way to get past this? and
Are there libraries available specifically for this shield?
Thanks for reading.
a=arduino('COM6','Uno','Libraries'{'Adafruit/MotorShieldV2','I2C','RotaryEncoder'});
mot=addon(a,'Adafruit/MotorShieldV2');
% Here is where I have trouble
dcm= dcmotor(mot,'port'); % I cannot specify a port
% What I mean is that the Rev3 motor shield does not specifiy "M1" or "M2" insead it uses "Channel A and B" so this is a problem
0 commentaires
Réponses (0)
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!