how to control dc motor by matlab gui with adafruit motorshield V1?
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
please help to control dc motor by matlab gui with arduino adafruit shield V1
Réponses (1)
Tony Lennon
le 9 Août 2019
Please take a look at this video. https://www.mathworks.com/videos/using-matlab-and-arduino-for-motor-control-100737.html
It's not exactly the same HW setup, but close.
2 commentaires
amin ya
le 10 Août 2019
This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.
Madhu Govindarajan
le 12 Août 2019
Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html
If you end up creating an add-on, please share with community using File Exchange.
Regards,
Madhu
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!