how to solve error "Failed to generate all binary output" in android device simulink?

I want to try an example of Android device simulink on my phone.

But i got this error.

can anyone help?

Answer 1

[Sruthi Yenugula]

Please note, the Camera block works fine with Android SDK Build Tools 28.0.3. However, if build tool version 29.0.0-rc2 is present then the above issue comes up.

To resolve the issue, you can uninstall build tool 29.0.0-rc2 and install version 28.0.3. After uninstalling, please run Android Hardware setup again. Then try deploying the model to the Android Device.

[itthipol intaseang]

Where can I find and uninstall build tool 29.0.0-rc2?

Answer 2

[Sruthi Yenugula]

Use this link , to open sdk tools page.

Follow the below steps in the SDK tools page.

In the right corner, there is a checkbox (Show package Details), click that. Now under Android SDK Build-Tools in the same tab, you can uncheck 29.0.0-rc2,29.0.0-rc1 and check 28.0.3, then click apply. Check the attached screenshot for more information

[itthipol intaseang]

It still dont work, same error.

[Sruthi Yenugula]

After uninstalling the build tools, run Android Hardware setup again(https://www.mathworks.com/help/supportpkg/android/ug/install-support-for-android-devices.html#mw_ce00da2f-bde9-4f39-a69a-a9aaf014dbc0). After that delete the generated project folder and try to build the model.

[itthipol intaseang]

I have done all this but it still same error.

[Sruthi Yenugula]

Can you provide the output of the following command(type it in MATLAB command prompt)

codertarget.android.AppBuilder

[itthipol intaseang]

[Sruthi Yenugula]

After uninstalling build tools, hardware setup is not done again or the build tools is not uninstalled. I can see still your build tools version is 29.0.0rc2. Please try all the steps or else please contact technical support, they will guide you.

[itthipol intaseang]

Thank you sir, after all these day you help me solve my error.

Finally it completed, thank you very much.