how to display result from matlab to LCD

how to display the final result into LCD arduino?

here is my code for the image processing which assigned to count the number of blackheads.

i want the LCD to display the number of blackhead counted.

and what about the code for the arduino?

I = imread('psm1.png');
figure
imshow (I);

Im=I,

rmat=Im(:,:,1);
gmat=Im(:,:,2);
bmat=Im(:,:,3);

subplot(2,2,1),imshow(rmat);
title('Red');
subplot(2,2,2),imshow(gmat);
title('Green');
subplot(2,2,3),imshow(bmat);
title('Blue');
subplot(2,2,4),imshow(I);
title('Original');

levelr=0.52;
levelg=0.52;
levelb=0.52;
i1=imbinarize(rmat,levelr);
i2=imbinarize(gmat,levelg);
i3=imbinarize(bmat,levelb);
Isum=(i1&i2&i3);

figure,
subplot(2,2,1),imshow(i1);
title('Red');
subplot(2,2,2),imshow(i2);
title('Green');
subplot(2,2,3),imshow(i3);
title('Blue');
subplot(2,2,4),imshow(Isum);
title('Sum of All Colour');
Icomp = imcomplement (Isum);
Ifilled = imfill(Icomp,'holes');
figure, imshow(Ifilled);

se=strel('disk',20);
Iopenned=imopen(Ifilled,se);
imshow(Iopenned);

Iregion=regionprops(Iopenned, 'centroid');
[labeled,numObjects]=bwlabel(Iopenned,4);
stats = regionprops (labeled, 'Eccentricity','Area','BoundingBox');
areas = [stats.Area];
eccentricities = [stats.Eccentricity];

idxOfSubjects=find(eccentricities);
statsDefects=stats(idxOfSubjects);

figure,imshow(I);
hold on;
for idx = 1: length(idxOfSubjects)
    h = rectangle('Position',statsDefects(idx).BoundingBox);
    set(h,'EdgeColor', [.75 0 0]);
    hold on;
end
if idx<10
    title([ ' ',num2str(numObjects),' blackheads detected']);
    
  

end
hold off;

[Talent Mukaro]

Hie, kindly advice how you solved this? I'm facing the same problem. Email [e-mail] or app [phone]. Thank you

Answer 1

[Joris Naudin]

Hi,

Did you downloaded an add-on for communicating Arduino with Matlab ? Then you can check some examples.