two-phase fluid Simulink
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
I am having some troubles simulating a hydraulic model with a two-phase fluid in Simulink (using Simscape Fluids)
The model works properly when the inputs in the "Two-Phase Fluid Properties (2P)" block are defined within the subcritical region (Pcritical = 46 bar in my model). However, when I extend the pressure vector (and the other thermophysical properties of the fluid) over the critical pressure specified in the block, the following error pops up:
Error compiling Simscape network for model aaaa.
Caused by:
- ['model/block': In foundation.two_phase_fluid.utilities.two_phase_fluid_properties (line 898)
The bold equation below seems to be popping up the error message:
if n_sub < n
assert(all(v_sat_liq_sup(:) == v_sat_vap_sup(:)))
assert(all(s_sat_liq_sup(:) == s_sat_vap_sup(:)))
assert(all(T_sat_liq_sup(:) == T_sat_vap_sup(:)))
assert(all(nu_sat_liq_sup(:) == nu_sat_vap_sup(:)))
assert(all(k_sat_liq_sup(:) == k_sat_vap_sup(:)))
assert(all(Pr_sat_liq_sup(:) == Pr_sat_vap_sup(:)))
I have defined the liquid and vapor-saturated curves over the critical pressure to be exactly the same but still getting that error...
Anybody had similar problems? I Would appreciate any comment/hint with this.
Thanks!
Alejandro.
0 commentaires
Réponses (0)
Voir également
Catégories
En savoir plus sur Upgrading Hydraulic Models to Use Isothermal Liquid Blocks dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!