How to apply FIR low pass filter to a dataset

1 vue (au cours des 30 derniers jours)
Dongwei Bai
Dongwei Bai le 11 Juin 2019
Commenté : Jan le 11 Juin 2019
I have a data set which is torque vs time shown below that I need to remove the noise using low pass filter. However, I don't know what value should I use for each variables in the filter design.
  1 commentaire
Jan
Jan le 11 Juin 2019
This cannot be answered in general, because it depends on the frequency spectrum of the noise. The readers cannot guess magically, which parts of the this curve has to be considered as "signal" and which as "noise", so you need a physical analysis of the system.

Connectez-vous pour commenter.

Réponses (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by