Field oriented control on Zynq Zedboard without the FMCMOTCON2 module.
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Zaeem Gauher
le 21 Juin 2019
Réponse apportée : Joel Van Sickel
le 18 Août 2020
I am trying to implement the Field oriented motor control example found here: https://www.mathworks.com/help/supportpkg/xilinxzynq7000ec/examples/field-oriented-control-of-a-permanent-magnet-synchronous-machine.html
I do not have the FMCMOTCON2 driver module that comes with the kit ( I have the Zedboard and the Dyno). Can I use another driver board such as the Enclustra FMC DR2? If so, do I need to change any parameters in the simulink model for this example?
0 commentaires
Réponse acceptée
Joel Van Sickel
le 18 Août 2020
Hello Zaeem,
You can use the fundament control algorithm with any driver, assuming that driver is appropriately speced for your system. Assuming you are only changing the driving hardware, most parameters in the simulink model will not need to change. However, you will need to investigate the interface to the new driver and make sure that all signals are scaled/typed appropriately and the signals go to the correct i/o channels, as the interface is probably somewhat different.
Regards,
Joel
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Hardware-in-the-Loop Simulation with Simulink Real-Time dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!