How do I limit the rotation of a revolute joint in Simscape Multibody? Setting the internal limits is not working
55 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have several links attached to eachother by revolute joints. I apply a ramp input at the joint attached to the world frame, but I want to stop the joint when it gets to an angle 220 degrees from where it started. I specify the upper and lower limits in the revolute joint block, but when I run it, the joint is still moving past the upper limit. How do I get this to work? Or is it possible to use the rotational hard stop block? This block is green so it seems to be a part of Simscape driveline so I don't know how I would attach it to my physical multibody model. Thanks!
0 commentaires
Réponses (1)
Divya Yerraguntla
le 24 Juil 2019
Hi,
I found an answer to a similar question.
1 commentaire
Milando
le 11 Oct 2021
Hi,
the solution proposed in your link is already integratet in Simulink as the limit-inputs for the joints.
Even with the Simmechanic Interface, the joint will ignor the limits (by given motion).
Are there any other solutions for this problem?
Voir également
Catégories
En savoir plus sur Assembly dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!