simulation of stepper motor with microstepping
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hey all, I've been trying to simulate a hybrid stepper motor by using microstepping. Therefore, i took the power_steppermotor demo that comes with matlab/simulink and intended to feed it with a signal similiar to the one explained on page 8, http://www.deltron.ch/pdf/produkte/motoren/Schrittmotor_kurz_erklaert_d.pdf However, given the stepper motor demo, I get an unstable system reply just by decreasing the required step angle in the motor parameter dialog box to less than 0,45°. Is there any example for a stepper motor in micro step control? I'm looking for a couple of hours so far but I'm unable to find anything appropriate... Hope you can help me out somehow.
br
Kev
2 commentaires
Réponses (1)
Sabin
le 7 Jan 2023
A good starting point is the Stepper Motor Averaged Mode example in Simscape Electrical. In this example there are three stepping methods: Full stepping, Half stepping, and Microstepping.
0 commentaires
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Electromechanical dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!