Target communication in Simulink Real-time 2016a
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
I want to use a motion controller(with i486 inside) to be my target PC. However, the ethernet device isn't supported by MATLAB. I try to use the Ethernet adapter(from usb to ethernet with USBA88772 chip inside). The problem is that when I boot my target device, target PC shows the networking information(not system haleted error) but it cann't connect to real-time explorer. The problem is same for my serial port connection when I try the MATLAB 2014b. I think the target PC have found the hardware but it can not communicate.
I have tried the same network setting on another PC(with Intel etherent device inside) and it works. Can anyone give me some suggestions ?
Thank you!
1 commentaire
Mounika Patel
le 23 Juil 2019
You can refer to below documentation link which details about the troubleshooting the problems you encounter using Simulink Real-Time product:
Réponses (0)
Voir également
Catégories
En savoir plus sur Target Computer Setup dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!