How to simulate and verify a dc motor performance on simscape
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Andrea Ongaro
le 9 Août 2019
Réponse apportée : Steve Miller
le 4 Août 2020
Hi everyone,
i'm trying to verify if a dc motor+transmission system is suitable for an application and if the force that is actuated is enough.
To be precise enough what could be the suitable way to verify if the force is enough? the first problem is the simulation of the load, that is a load that increase up to 200 N in a space of 3 mm and reched this peak, goes down quite vertically.
Do you some advice for me? i'm quite a beginner with matlab and simscape, so i hope to get some advices.
Thanks in advance.
2 commentaires
Nikhil Sonavane
le 19 Août 2019
It would be better if you can give a detailed explaination of your problem statement. Also, if possible share your simulation model.
Réponse acceptée
Steve Miller
le 4 Août 2020
I think all you need to add is a force sensor to see how much force your actuator is delivering.
I have attached an updated model, and you can see how to add the sensor in the screenshot below.
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Permanent Magnet dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!