Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Shubham Yadav
le 19 Août 2019
Commenté : Danny
le 23 Fév 2024
Hi,
I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.
Thanks a lot.
0 commentaires
Réponse acceptée
Roshni Garnayak
le 22 Août 2019
Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.
To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:
2 commentaires
Danny
le 23 Fév 2024
That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Real-Time Simulation dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!