problems connecting a Voltage Measurement Block to parallel RLC branch circuit.
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
RE: SimPowerSystems. When I try to connect a Voltage Measurement block to a "terminal" on the Parallel RLC branch block all I get is a dashed red line indicating no connection.
When I instead try to connect to the branch in the middle of the existing connection line, a "tie point" is created and the connection turns black. It appears to connect properly. Alas when I attempt to run the simulation it indicates that the voltage measurement block input is not connected.
0 commentaires
Réponses (1)
Joel Van Sickel
le 11 Déc 2020
I'm sorry this answer comes too late to be useful:
It sounds like the first issue is a UI bug preventing connection of lines that should work. As I can no longer check the images, I must assume that in the 2nd case, the voltage measurement was not connected correctly such as to give the correct output. That issue has certainly been fixed at this point.
0 commentaires
Voir également
Catégories
En savoir plus sur Variable Initialization dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!