F28379D-Simulink data monitoring: PWM signals

14 vues (au cours des 30 derniers jours)
Praveen Kumar
Praveen Kumar le 30 Oct 2019
Commenté : Mohammad Qaza le 27 Déc 2023
Hi,
I am learning to use TI F28379D interface with Simulink. I saw examples of data monitoring where voltage, currents data are monitored in simulink using external mode and C2000_host_read_12M example (not clear how works).
I would like to generate a PWM signal of certain freq and is it possible to monitor it in simulink? Since ePWM block doesnt have any output pin, I cant connect any scope. I could monitor the input in external mode.
  1 commentaire
Mohammad Qaza
Mohammad Qaza le 27 Déc 2023
Hi, I'm trying to do the same. have you been able to figure this out??
Thanks in advance.

Connectez-vous pour commenter.

Réponse acceptée

Venkatesh Chilapur
Venkatesh Chilapur le 4 Nov 2019
Hi,
Please check the below link for an idea on Host-Target SCI setup.
ePWM block act as driver block such that it can generate the code and run the same on the target. It has no simulation capability to show what output pattern will be generated. We can only see this output on a PWM pin on the hardware using DSO.
HTH,
Regards,
Venkatesh C

Plus de réponses (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by