Why do I get an error about a missing target data map file, although I am using XCP external mode?
21 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
MathWorks Support Team
le 13 Fév 2020
Réponse apportée : MathWorks Support Team
le 13 Fév 2020
I am trying to run my application using XCP-based external mode. However, I see the following error message about a non-existing "model_targ_data_map" file when I try to connect to the target:
>> set_param(modelname, 'SimulationMode', 'external');
>> set_param(modelname, 'SimulationCommand', 'connect');
Could not execute target data map file 'myModel_myTarget_rtw\myModel_targ_data_map' or it does not exist.
Stop the target, delete the myModel executable, rebuild the code, and try again.
Note that execution of external mode requires the build directory to be present
Réponse acceptée
MathWorks Support Team
le 13 Fév 2020
XCP-based External Mode does not generate a target data map file. Therefore, we suspect that the the default setup of the External Mode transport layer was modified and the current values are incorrect.
Please type from the MATLAB console the following commands:
>> idx = get_param(modelName, 'ExtModeTransport')
>> cs = getActiveConfigSet(modelName)
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
In order to run XCP-based External Mode, you should see the following output:
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
transport =
'XCP on TCP/IP'
mexfile =
'ext_xcp'
interface =
'Level2 - Open'
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Multicore Processor Targets dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!