shows table in gui panel

Hi

I have made this code to show my table in gui, but the table just pops up and does not show in the gui application

handles.T = table((1:(size(nCoord,1)-1))',x_globalx(:,1),x_globay(:,1),x_globarz(:,1), 'VariableNames',VarNames)
fig = uifigure;
uit = uitable(fig, 'Data',handles.T);
set(handles.uitable1, 'Data', handles.T);   ( this is the one i think i have made wrong )

[Adam Danz]

It looks like you're using a GUIDE GUI. Please confirm.

The line uit=uitable(...) creates the UI table but the UI table should already exist. So, remove that line.

The set(...) line should be sufficient if the handles are all correct.

[polo Mahmoud]

hi

Yes I use GUI, but i tried to dele the uit code and only used the set(..) but it did not work.

[Adam Danz]

"Yes I use GUI"

There are several ways to make a GUI in Matlab. I'm asking specificlly if you've used the guide() method. Based on your variable names, I think this is the case.

"...but it did not work"

I don't know what that means. Did you get an error message(if yes, please share the entire copy-pasted error message)? Did the table data no appear? Did something else happen unexpectedly?

[polo Mahmoud]

Hi

Yes i have used guide, and the there was error :

Error using matlab.ui.control.Table/set
Functionality not supported with figures created with the figure function. For more information, see
Graphics Support in App Designer.

Error in New_gui_polo_16_02>pushbutton15_Callback (line 966)
set(handles.uitable4, 'Data', handles.T);

Error in gui_mainfcn (line 95)
        feval(varargin{:});

Error in New_gui_polo_16_02 (line 42)
    gui_mainfcn(gui_State, varargin{:});

Error in
matlab.graphics.internal.figfile.FigFile/read>@(hObject,eventdata)New_gui_polo_16_02('pushbutton15_Callback',hObject,eventdata,guidata(hObject)) 
Error while evaluating UIControl Callback.

Answer 1

[Adam Danz]

"Error using matlab.ui.control.Table/set; Functionality not supported with figures created with the figure function."

handles.T should be a cell array instead of a table. You can either create the cell array directly instead of creating a table, or you can convert the table to a cell array using table2cell().

Then you can use

set(handles.uitable1, 'Data', handles.T); 
%                  cell array ^^^^^^^^^

[polo Mahmoud]

Thank you very much :D

[Adam Danz]

Glad I could help pinpoint the problem.

[Diego Guisasola Plejo]

Thank you so much, I've been trying to solve this for the past 2 hours and it was a datatype problem. Thanks!