How to perform handshaking operation
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello, my project is to transmit data to the analog output pin of MCC USB 205 DAQ. From the DAQ the data goes to ADI Board for further process. To increase the speed of data transmission I am using a C mex file to transmit data. Now I want to implement handshaking operation to transmit the data. I have 3 data's to transmit (a,b,c) based on the rising edge and falling edge of clock. I am totally new to this, can anybody give suggestions like how to do it, where to start with, or any example code or documents.
0 commentaires
Réponse acceptée
Walter Roberson
le 27 Fév 2020
Unless the clock rate is very slow, there is no realistic way to monitor the clock edge at the MATLAB level in order to determine when to transmit the signal.
This is the sort of task that you use an external device to handle the timing and signal transmission. Some daq boards can handle it: you command them with trigger information and appropriate response and let them run independently.
9 commentaires
Walter Roberson
le 2 Mar 2020
I need to transmit 1x256 double data (it corresponds to image pixels) to analog output pin 0
You need to transmit the bit sequence corresponding to the IEEE 754 Double Precision representation of each pixel?? If so, in what bit order?
Or for each pixel, you need to transmit a single voltage that corresponds to (say) pixel-value/(2^16) or pixel-value/256 of full voltage, and it is acceptable if the remote end does not exactly reconstruct the same voltage?
Or... ??
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Troubleshooting in Data Acquisition Toolbox dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!