How can I modify the manipulated variable properties in a MPC block in Simulink?
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm developing the MPC controller for ventilator.
![](https://www.mathworks.com/matlabcentral/images/broken_image.png)
Plant model consist of 3 inputs and 1 output.
Three inputs are ventilator on/off(manipulated variable), occupancy sch. (measured disturbance 1) and outdoor co2 (measured disturbance 2).
One output is indoor co2 (measured output).
I want to control the ventiltor to only the on/off (0, 1).
I set the minimum and maximum constraints of manipulated variable(vantiltor on/off), It is 0 and 1 respectively.
And I set the max down rate and max up rate. it is -1 and 1 respectively.
However, the calculated result of manipulated variable include values between 0 and 1.
![](https://www.mathworks.com/matlabcentral/images/broken_image.png)
How could I fix this problem?
Thanks.
1 commentaire
Imaneky
le 16 Oct 2018
Hi,
Have you find a solution to your problem?
I am trying to implement an MPC for a bang-bang control output.
Thank you!
Réponses (2)
Ryan G
le 16 Oct 2012
I don't know if I would normally use a MPC control for a bang-bang (on/off) control scheme, but then again I'm not really that familiar with MPC.
0 commentaires
Azzi Abdelmalek
le 16 Oct 2012
Modifié(e) : Azzi Abdelmalek
le 16 Oct 2012
pass your input signal through a zoh (zero order hold) block from simulink/discret. or set your signal source datype to logical
0 commentaires
Voir également
Catégories
En savoir plus sur Linear Plant Specification dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!