Info
Cette question est clôturée. Rouvrir pour modifier ou répondre.
How can we change output state of delay block during simulation ot its initial value using command prompt
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I want to change output state of delay block to initial value during simulation.
This should happen when that subsystem gets enabled.
But I dont want to change "States when enabling" property to "Reset". Is this possible what enable block do we can do using command prompt? So it will change state of output block as same as when enable subsystem "Reset"
0 commentaires
Réponses (2)
Kaustubha Govind
le 16 Oct 2012
If you use the Unit Delay Resettable block, you should be able to reset it using the reset input port instead.
2 commentaires
Kaustubha Govind
le 17 Oct 2012
Could you explain what you mean by: "MATLAB do this in the background depending upon option selected in enable port mask."
AFAIK, that setting cannot be changed during simulation. If you want to do it before simulation starts, you can of course use:
set_param('path/to/enable/port', 'StatesWhenEnabling', 'reset')
If you can't change that block (library block?), then perhaps you could connect another Enable Subsystem at the output of that block and used the solution I suggested here. Use the same initial condition as that for the library block.
Azzi Abdelmalek
le 16 Oct 2012
Modifié(e) : Azzi Abdelmalek
le 16 Oct 2012
if ModelName is your model name
set_param('ModelName/Unit Delay','x0','10')
0 commentaires
Cette question est clôturée.
Voir également
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!